Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
hardware:pump [2019/04/11 19:09]
kvriet
hardware:pump [2019/04/11 19:35] (current)
kvriet
Line 3: Line 3:
 The pump we use is from Schoonewil Techniek https://​schoonewiltechniek.nl/​product/​piccolo/​. The piccolo is normally used for concrete repair but can also be used for 3D concrete printing with a flow rate of 0.5 to 8 liters per minute. The biggest reason we have chosen this pump is because this pump is adjustable to 10 positions. Because the printing of concrete is very accurate, it is important to have a lot of control over the pump. The pump we use is from Schoonewil Techniek https://​schoonewiltechniek.nl/​product/​piccolo/​. The piccolo is normally used for concrete repair but can also be used for 3D concrete printing with a flow rate of 0.5 to 8 liters per minute. The biggest reason we have chosen this pump is because this pump is adjustable to 10 positions. Because the printing of concrete is very accurate, it is important to have a lot of control over the pump.
  
-There are no concrete pumps available yet that are relatively inexpensive and robust and, on the other hand, can withstand ​the stiffness ​of 3D concrete mortar. Now it's still important to keep an eye on the pump and keep tamping the mixture.+There are no concrete pumps available yet that are relatively inexpensive and robust and, on the other hand, can handle ​the thoxitropical behaviour ​of 3D concrete mortar.
  • hardware/pump.1555002574.txt.gz
  • Last modified: 2019/04/11 19:09
  • by kvriet