Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
hardware:nozzle [2019/04/17 10:16]
kvriet [Files]
hardware:nozzle [2019/04/17 10:17] (current)
kvriet
Line 31: Line 31:
  
 When you open the file, you will see the following warning in the console: "​DEPRECATED:​ polyhedron(triangles=[]) will be removed in future releases. Use polyhedron(faces=[]) instead."​ In the version of OpenSCAD used to create the nozzle (2015.03) this is not a problem and the nozzle will render just fine. When you open the file, you will see the following warning in the console: "​DEPRECATED:​ polyhedron(triangles=[]) will be removed in future releases. Use polyhedron(faces=[]) instead."​ In the version of OpenSCAD used to create the nozzle (2015.03) this is not a problem and the nozzle will render just fine.
- 
-===== Nozzle test ===== 
- 
-Recently we tested the round nozzle design, comparing different diameter. Here are some photos of the different nozzle diameters and the resulting concrete prints. 
- 
-{{:​nozzle_test_print_overview.jpg?​direct&​400|}} 
- 
-{{:​nozzle_test_10mm.jpg?​direct&​400|}} 
- 
-{{:​nozzle_test_15mm.jpg?​direct&​400|}} 
- 
-{{:​nozzle_test_18mm.jpg?​direct&​400|}} 
- 
- 
-{{:​nozzle_test_2_bottom.png?​direct&​400|}} 
  
 ~~DISCUSSION:​off~~ ~~DISCUSSION:​off~~
  • hardware/nozzle.txt
  • Last modified: 2019/04/17 10:17
  • by kvriet